1/1/2023 0 Comments Installing non mortise hinge![]() ![]() ![]() As a result, the doors were 'spring loaded' and did notclose, thus the magnetic catches would not hold. Myproject involved doors with small outside radius' so therefore the hinge(door side) when installed, did not result in a true 90 degree relativeinstallation. Note that above flush screwheads is a very common problem with this type of hinge.28) Submitted by John, from Winston Salem, NC on I was surprised to discover that these hinges do not maintain square ifinstalled on anything other than 'exact' 90 degree corners/edges. If you knew that andpurchased some replacement screws maybe the problem is that the heads donot flush down into the counter sunk hole. ![]() In article, says.Read some of the review comments from the Rockler web site regardingthese hinges. You might be able to see if it'shitting somewhere else.Mike O.Michael Karas27.06.10 22:14. You would expect to just see the littlesquare smashed out of the paper. The hinge I'm using ison the right.Are the screws flush with the face of the hinge? If even one ishanging out a little (on either the door or the cabinet) it will hitthere before the door is closed.You might try cutting a notch in a piece of paper (so you can hold onto it) then stick it through the crack at the hinge and closing thedoor on top of the paper. On Sat, 21:38:46 GMT, me wrote:It'sbut the middle isn't notched. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |